 |
 |
|
Products > Network Operators > Active Systems |
    |
|
|  |
|
| |
|
|
| |
 ConRep: SFP Media Converter / Repeater
|
|
The ConRep series SFP converters and repeaters offer a very simple and low-cost option to convert (e.g. from "grey to colored") SFP transceivers or to extend the network reach via repeating the SFP signals. The ConRep CR200 is a standalone 1HU unit with 2 redundant power supplies to convert / repeat up to 4 channels, from 155 Mbit/sec to 2.67 Gbit/sec. The ConRep 1700 and ConRep 6000 are line card based in 5HU or 2HU chassis with network management and can repeat / convert up to 32 channels.
|
|
| |
 CR200 |
| |
1HU standalone Converter/Repeater for up to 4 SFP based channels |
| |
ConRep 1700 & ConRep600 |
| |
2HU / 5HU line card based Converter/Repeater with network management option |
 ConRep: Multi-protocol 10G transponder
|
|
The PM 1001 transponders are part of the ConRep Series and are used as 10G or OC-192 signal repeaters, long haul extenders and as DWDM transponders. In addition, they have the unique capability of converting between the different 10G standards and can convert from 10GbE LAN PHY to 10GbE WAN PHY.The PM 1001 supports all 10G protocols from 9.95 Gb/s to 10.709 Gb/s, including 10GbE LAN PHY, 10GbE WAN PHY, OC-192/STM-64 and 10G Fiber Channel.
|
|
|
ConRep: Fiber Media Converter
|
|
The ConRep standalone Fast Ethernet to Fiber Media Converter series are simple and low-cost manageable converters, which give you the options to choose from the most popular fiber cabling connectors, ST, SC, or FC. Both multi-mode and single mode converter models are available as well as BiDi which allows bi-directional transmissions using only a single fiber cable. When auto-negotiation is selected, these units will automatically tailor themselves to convert both half-duplex and full-duplex signals, depending on your specific network needs. LED indicators signal the power status of the converter, UTP port speed, Link, and duplex status, FX port Link and duplex status.
|
|
|
|
LightPilot
Whether you need to extend your passive network to wider distances or have to make media conversion to use legacy equipment, the LightPilot is the a low-cost and stand-alone option for both. Since the set-up is very flexible the LightPilot may be tailored to your specific needs.
|
 |
Please, contact us for further configurations and modules. We as well provide additional equipment as regenerators, boosters etc. on request. |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
